In Australia and New Zealand, the AS/NZS 3000 standard, commonly known as the "wiring rules", specifies requirements for the selection and installation of electrical equipment, and the design and testing of such installations. The standard is mandatory in both New Zealand and Australia; therefore, all electrical work covered by the standard must comply.
Most of wiring diagram software has a unique feature for electrical cabling: the wiring diagram or single line diagram, allowing a simplified representation of an electrical cabling installation in pre-study phase.
A wiring diagram usually gives information about the relative position and arrangement of devices and terminals on the devices, to help in building or servicing the device. This is unlike a schematic diagram, where the arrangement of the components, interconnections on the diagram usually does not correspond to the components, physical locations in the finished device. A pictorial diagram would show more detail of the physical appearance, whereas a wiring diagram uses a more symbolic notation to emphasize interconnections over physical appearance.
In North American practice, an overhead cable from a transformer on a power pole to a residential electrical service usually consists of three twisted (triplexed) conductors, with one being a bare neutral conductor, with the other two being the insulated conductors for both of the two 180 degree out of phase 120 V line voltages normally supplied. The neutral conductor is often a supporting "messenger" steel wire, which is used to support the insulated Line conductors.
relay wiring diagram
wiring diagram schematics
switches wiring diagram
Daisy chain light wiring diagram electrical phone
Can bus termination related keywords suggestions international dt466 fuel wiring diagram on schematic can termination house simplified motor coil connection hid ballast c 1100x1062
Electrical control wiring diagram in maxresdefault daisy chain
Diagram daisy chain phone wiring electrical speaker light arduino